An Avaya customer with a large contact center is IP enabling their S87xx and will allow 25 users to work from home via IP Agent in the Telecommuter mode. What is the minimum hardware required in the S87xx to provide this application?

A. one CLAN board only

B. one Media Processor board only

C. one CLAN and one Media Processor board

D. no hardware is required, only software.

Which two design considerations must be re-examined any time additional capacity is added to an Enterprise Survivable Server (ESS) strategy? (Choose two.)

A. avoid fragmenting the system

B. avoid overloading of network resources with excessive call traffic

C. avoid locally sourced Music on Hold (MOH) and Voice Announcements over LAN (VAL)

D. consider the number and type of trunks between ESS and Local Survivable Processor (LSP) locations

Your client is requesting a design that includes 750 IP Telephony endpoints, 75 digital endpoints, 45 analog endpoints and 5 ISDN PRI facilities. During the process you need to design the network regions with the client. What information is needed to define the network regions? (Choose three.)

A. IP endpoints that are grouped geographically

B. IP endpoints that incorporate the same dial plan

C. IP endpoints included in communities of interest

D. IP endpoints using the same compression method

Your client has an existing S8500 Media Server with G700 Media Gateways running Communication Manager (CM) R1. Your client wants interoperability with Session Initiated Protocol (SIP) endpoints. What do you tell your client?

A. SIP interoperability is being considered, a firm interoperability date is not available at this point.

B. The SIP protocol is still evolving. When it is finalized, Avaya will make interoperability available.

C. The introduction of SIP interoperability became available with CM Release 2. An upgrade will be required.

D. With their existing system, SIP interoperability is supported via third-party SIP/ H.323 conversion servers.

Which two design issues relate to increasing security in VoIP converged solutions? (Choose two.)

A. suggesting upgrading LAN switches to support QoS

B. defining VLANs to limit access from specific IP endpoints

C. considering encryption on IP calls for protection from eavesdropping

D. considering G.729 compression to protect IP calls from eavesdropping

In combination with an Avaya SIP Telephone, which option below supports shuffling where no DSPs are utilized during an active call (peer-to-peer RTP)?

A. 96xx SIP and 2400 Series Digital phone

B. 46xx SIP and Analog phone

C. 96xx SIP and 46xx H.323 phone

D. 96xx H.323 and 46xx H.323 phone

When carrying voice traffic over VPNs, what negatively affects voice performance? (Choose two.)

A. Network Address Translation (NAT)

B. The additional delay due to the encryption process

C. An acceptable level of service with the VPN provider

D. Excessive packet loss, delay, and jitter for traffic crossing the Internet

Your Customer wants to have a Call Center environment with IP Telephones, they want to have the maximum reliability/survivability you can offer. Which of the following you will recommend?

A. S8500 with duplicated IPSI, duplicated media processors and duplicated C-LANS.

B. S87XX with duplicated G650, duplicated IPSI's, duplicated media processors, duplicated C- LANS and duplicated control networks.

C. S87XX with one G650, duplicated IPSI's, duplicated media processors, duplicated C-LANS and duplicated control networks.

D. S8300 LSP with a G450.

A customer has an Avaya S87xx Media Server with an Avaya G650 Media Gateway. They want the

remote site tied-in to the main. The remote site has a DSL line for Internet access. They currently have a

secure VPN tunnel to the main site and want to implement VoIP over this tunnel.

What is your biggest concern as a designer?

A. NAT issues

B. Implementation issues

C. Security cannot be guaranteed

D. Voice quality cannot be guaranteed

You have just installed a G700 Gateway with LSP at a remote location. The G700 will be placedin Network Region 5, and register with an S8500 Media Server at the corporate headquarters. What should you do to configure the QoS settings for the G700 in Network Region 5?

A. Log in to the S8500 and configure the network map

B. Log in to the S8300 LSP and configure the Network Region Form

C. Log in to the G700 and configure the Network Region for the remote site

D. Log in to the S8500 and configure Network Region Form for the remote site