Which prompt is used to configure parameters for the Ethernet ports of an industrial switch?
A. Switch(config-if)#
B. Switch(config-if-ind)#
C. Switch(config-line)#
D. Switch(config-ind)#
E. Switch(config-vlan)#
Exhibit:
Refer to the exhibit. An industrial ruggedized network device needs to be installed in the place of the icon labeled Network Device to accommodate a leased line attachment to the Internet. Which network device and interface configuration meets the minimum requirements for this installation?
A. a router with two Ethernet interfaces
B. a switch with two Ethernet interfaces
C. a router with one Ethernet and one serial interface
D. a switch with one Ethernet and one serial interface
E. a router with one Ethernet and one modem interface
Which characteristic causes multimode fiber-optic cable to differ from single mode?
A. by allowing multiple network services in the same cable
B. shorter maximum network segment length for a given bandwidth
C. a wider variety of available connector types
D. use outdoors as well as indoors
A network administrator has subnetted the 172.16.0.0 network using a subnet mask of 255.255.255.192. A duplicate IP address of 172.16.2.120 has accidentally been configured on a workstation in the network. The technician on the plant floor must assign this workstation a new IP address within that same subnetwork. Which address should be assigned to the workstation?
A. 172.16.1.80
B. 172.16.2.80
C. 172.16.1.64
D. 172.16.2.64
E. 172.16.2.127
F. 172.16.2.128
In which two ways could you minimize the impact of monitoring an industrial network? (Choose two.)
A. Send random messages to a device and see what the response is.
B. Do frequent ping sweeps to industrial devices to check for their proper operations.
C. Make a copy of all the network traffic and analyze it offline.
D. Use an industrial-network-grade IDS-IPS system.
What is the leading cause of fiber-optic link failure?
A. contaminants
B. crushed fiber
C. poor testing practices
D. bad connectors
What two things does a router do when it forwards a packet? (Choose two.)
A. switches the packet to the appropriate outgoing interfaces
B. computes the destination host address
C. determines the next hop on the path
D. updates the destination IP address
E. forwards ARP requests
What does the Cisco PSIRT issue for significant security issues that directly involve Cisco products and require an upgrade, fix, or other customer action?
A. Cisco Security Advisories
B. Cisco Security Responses
C. Cisco Security Notices
D. Cisco Security Bulletins
What is the purpose of a time domain reflectometer?
A. It uses pulses to locate and test for sheath faults, damaged conductors, loose connectors, splices, bridge taps, split pairs, and other problems.
B. It opens shorts and pinholes in cable shielding.
C. It correlates the returned light pulses with a location in the fiber.
D. It opens kinks and mismatched cable connectors.
What are two benefits that are provided by proper grounding and bonding systems? (Choose two.)
A. higher speed communications
B. safe discharge of electrostatic energy
C. lower equipment power consumption
D. equipotential termination points for equipment and cable shields
E. lowest carbon footprint