When configuring a new Ethernet Routing Switch (ERS) 8000 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI.
How is the ACLI interface obtained?
A. by changing the interface type in the config.cfg file
B. by changing the ACLI boot flag and saving the boot configuration file
C. by exiting the CLI and choosing ACLI at the interface manager prompt
D. by use the abort command, and entering 'no' at the default interface prompt
During a power-on or cold-start sequence, at which stage can the flags to change the operational environment of the switch be set?
A. the boot monitor prompt
B. the image search
C. the system test
D. the boot configuration prompt
Within an STP enabled ERS 8000 switch, what will the vlan create
A. a port based VLAN
B. an ACL for a VLAN
C. a protocol based VLAN
D. a named VLAN
Which ACLI command is used to display SMLT port configuration?
A. show port smlt {fastethernet|gigabitethernet|mlt|pos}
B. show mlt {fastethernet|gigabitethernet|mlt|pos}
C. show smlt {fastethernet|gigabitethernet|mlt|pos}
D. show port info mlt {fastethernet|gigabitethernet|mlt|pos}
Refer to the exhibit.
While troubleshooting your VSP 9000 system, you run the command flight-recorder all
1. The associated files ace created.
Based on the information in the exhibit, where are the associated files stored?
A. Internal flash
B. TFTP Server
C. External flash
D. USB Flash device
A technician has installed the Advanced License. After initial configuration of an ERS 8000 system, the technician must also configure VRF for use on the network.
Which license enables the use of VRF?
A. the Advanced license
B. the Premier license
C. the Base license
D. the VRF License
A technician is configuring a Link Aggregation connection from a stack of Ethernet Routing Switch (ERS) 5500 switches, to a core pair of ERS 8000 switches. Which statement about the correct uplink configuration is true?
A. Distribute uplinks across different ERS 5500 switches in the stack.
B. Disable autonegotiation and replace it with VLACP to identify single fiber fault failure.
C. Use unique MLT IDs for each stack of edge ERS 5500 switches.
D. Enable Spanning Tree Protocol for the MLT when using it with SMLT in the core of the network.
What will the boot flag ftpd do to your system on startup?
A. enable the FTP Server daemon
B. disable the FTP Server daemon
C. allow the TFTP transfer of configs D. allow FTP traffic the highest DSCP
A customer is concerned about the security of their network. They need to understand the OSPF authentication options when accepting route updates in OSPF. Currently, their Virtual Services Platform (VSP) 9000 is configured to require no authentication when receiving the OSPF updates.
Which two supported authentication types would provide security on the VSP 9000 for OSPF updates? (Choose two.)
A. MD5
B. 3DES
C. RADIUS
D. Simple Password
EAPOL and 802.1X are examples of which kind of security within the ERS8000?
A. Routing
B. Data Path
C. Control Path
D. Management