Which two commands can be used to enable LUN reservations? (Choose two)

A. lun set reservation

B. lun reservation set

C. lun map

D. lun create

What are two performance tuning parameters available for Fibre Channel HBAs on a host? (Choose two.)

A. LUN queue depth

B. HBA BootBIOS enabled

C. Fibre Channel speed

D. LUN device ID

You connect a host to a NetApp storage system through an FC switch. The host has its boot volumes on the NetApp storage system. What is mandatory for you to configure?

A. persistent binding

B. port zoning

C. portsets

D. WWPN zoning

What is NetApp's recommended best practice for zone configuration?

A. All zones should contain a single initiator and all the targets that initiator accesses.

B. Individual zones can get too complicated. It is better to simply configure one default zone with all devices contained in it.

C. All devices from the same vendor should be in one zone.

D. All zones should contain a single target and all the initiators using that target.

When does Fractional Reservation reserve space from the volume?

A. Volume Creation

B. LUN Creation

C. LUN SnapMirror

D. Volume Snapshot

Which command can be used to identify the target iqn name in Data ONTAP 8.1 Cluster-Mode and later?

A. cluster iscsi name

B. cluster iscsi nodename

C. cluster iscsi show

D. vserver iscsi nodename

E. vserver iscsi name

F. vserver iscsi show

Which two Data ONTAP Cluster-Mode clone technology can clone an individual LUN inside a volume without cloning the entire volume?

A. FlexClone

B. LUN Clone

C. Snap Clone

D. Vol Clone

E. Aggr Clone

How many cluster switch(es) are required for a NetApp cluster?

A. 1

B. 2

C. 4

D. 6

To provide a complete connectivity and cabling plan prior to FC SAN deployment, which statement true?

A. VM administrators must be consulted to ensure optimum ESXi host loading

B. Once LUN mapping planning is complete, the job is done.

C. Final FC storage architecture is the sole requirement.

D. Switch and controller management network connectivity must be verified.

When applied to an igroup, what is the function of a portset?

A. A portset allows a host to utilize all of its paths equally.

B. A portset constrains the target ports where a LUN is visible to a host.

C. A portset specifies which paths to a LUN are Direct and Indirect.

D. A portset throttles the amount of traffic available to the hosts in that igroup