DRAG DROP

Drag and drop the characteristics from the left onto the Yang model they describe on the right.

Select and Place:

Which two best practices must be followed when designing an out-of-band management network? (Choose two.)

A. Enforce access control

B. Facilitate network integration

C. Back up data using the management network

D. Ensure that the management network is a backup to the data network

E. Ensure network isolation

Which control-plane technology allows the same subnet to exist across multiple network locations?

A. LISP

B. VXLAN

C. FabricPath

D. ISE mobility services

An architect is designing a multicast solution for a network that contains over 100 routers. The architect plans to create several multicast domains and balance the PIM-SM traffic within the network. Which technology should the architect include in the design?

A. DVMRP

B. IGMP

C. MOSPF

D. MSDP

Which control-plane protocol is used to map an endpoint to a location in a Cisco SD-Access network?

A. FabricPath

B. IS-IS

C. LISP

D. MP-BGP

An engineer is designing a network for a customer running a wireless network with a common VLAN for all APs. The customer is experiencing unicast flooding in the Layer 2 network between the aggregation and access layers. The customer wants to reduce the flooding and improve convergence time. Which solution meets these requirements?

A. Migrate all APs to a common Layer 2 access layer switch and run Layer 3 from the aggregation layer to all remaining access layer switches.

B. Align HSRP primary and STP root bridges and reduce ARP timers to match CAM timers on the aggregation layer switches.

C. Migrate to a Layer 3 access campus design if the APs can run on separate VLANs.

D. Align HSRP primary and STP root bridges if the APs cannot run on separate VLANs.

Which node performs the LISP Map-Server and Map-Resolver functions in the Cisco SD-Access network architecture?

A. control plane node

B. fabric edge node

C. border node

D. intermediate node

An engineer must peer with an ISP for internet connectivity using BGP, initially, the engineer wants to receive only specific prefixes from the ISP and a default route. However, the solution must provide the flexibility to add prefixes in the future at short notice. The ISP has a two-week change process in place. Which route filtering solution must the engineer employ?

A. Request a limited internet routing table and a default route from the ISP and configure the BGP max-limit to 1 with an access list that permits only the specific internet prefixes and blocked networks

B. Request only the required prefixes and default route be advertised from the ISO with whitelisted networks

C. Request a full internet routing table and a default route from the ISP and configure inbound route filtering with a prefix list that permits the default route and required prefixes

D. Configure outbound route filtering on the enterprise and ISP so that the enterprise tell the ISP which prefixes are required

Refer to the exhibit.

A network engineer is designing an OSPF solution to connect a company's remote to a newly provisioned MPLS VPN backbone. Some of the branches have a direct dark fiber connection between each other. The engineer wants to ensure that the dark fibers are used only when the MPLS core is unavailable. Which solution must the engineer choose?

A. Stub area

B. Sham link

C. Virtual link

D. NSSA

An engineermustdesign a management network for a customer's enterprise network. The design must: provide the ability to grant and revoke access privileges allow only protocols SSH, NTP, FTP, and SNMP restrict access to management Interfaces

Which solution must the engineer choose to meet the requirements?

A. in-band

B. enterprise internal private

C. out-of-band

D. mGRE