Refer to the exhibit. If the two devices are operating normally, which two conclusions can you draw from this configuration? (Choose two.)

A. CE1 must use OSPF to establish a neighbor relationship with PE1.

B. PE1 labels the routes it learns from CE1 with the route-target 222:2 and shares them with its VPNv4 peers.

C. PE1 labels the routes it learns from CE1 with the route-target 111:1 and shares them with its VPNv4 peers.

D. The PE-CE routes between the devices are being exchanged by OSPF

E. CE1 is supporting CSC.

An engineer needs to improve MPLS network management by implementing a set of tools to support the NOC engineers in troubleshooting network failures. Which feature should the engineer implement to check the connectivity of the MPLS LSP between the ingress and egress PE routers?

A. MPLS OAM

B. MPLS-TP

C. LDP autodiscovery

D. extended ping

Refer to the exhibit. A network operator is implementing EVPN IRB on PE1. Which two command placements enable the advertisement of Type 2 routes and what information do Type 2 routes contain? (Choose two.)

A. The operator adds in "host-routing" under the VRF EVPN.

B. Type 2 routes contain MAC/IP information.

C. Type 2 routes contain Ethernet Auto-Discovery information.

D. The operator adds in "host-routing" under the BVI651 interface.

E. Type 2 routes contain inclusive source-specific multicast route information.

Refer to the exhibit. An engineer is trying to configure an EVPN VWPS. What is the issue with this configuration?

A. The member in the VPWS context should be the PE-facing interface.

B. The 12vpn evpn command should be instance 101.

C. Interface GigabitEthernet0/1/0 should not have any IP address.

D. The service instance and the EVPN instance are different.

Refer to the exhibit. Which effect of this configuration is true?

A. It configures VPWS multihomed.

B. It configures VPWS single homed.

C. It configures an IPv4 peering with 192.168.1.1

D. It configures MPLS traffic engineering.

Which condition must be met before an environment can support CSC?

A. The CSC-PE and CSC-CE must each be able to ping an interface in its respective global routing table.

B. The CSC-PE and the CSC-CE must support IPv6.

C. The CSC-PE and CSC-CE devices must be able to send labels to one another using BGP.

D. The CSC-CE must support OSPFv3.

Refer to the exhibit. Which statement describes the result of this configuration?

A. R1 redistributes BGP routes into the OSPF process of VRF custabc as E1 routes.

B. R1 redistributes BGP routes into the OSPF process of VRF custabc as E2 routes.

C. R1 mutually redistributes routes between BGP 65001 and the OSPF process of VRF custabc.

D. R1 redistributes BGP routes into the OSPF process of VRF custabc as OIA routes.

Refer to the exhibit. A customer carrier running MPLS VPN wants to utilize a backbone carrier to forward traffic and exchange VPNv4 prefixes between the two customer carrier networks depicted. Which two sets of routers must establish MPiBGP sessions? (Choose two.)

A. BB-PE-A and CC-PE-B

B. CC-PE-A and CC-PE-B

C. BB-PE-A and BB-PE-B

D. CC-PE-A and BB-PE-A

E. BB-PE-A and BB-P-A

F. CC-PE-A and CC-P-A

Refer to the exhibit. A technician is troubleshooting a connectivity issue and notices that there is no IS-IS adjacency between R1 and R2. What can the technician change to bring the IS-IS adjacency up?

A. Change R2's net address to be in the same area as R1.

B. Change R1's is-type to level-2-only

C. Change R1's net address to be in the same area as R2.

D. Change R2's configuration to no longer set the overload bit.

Refer to the exhibit.

An organization is running H-VPLS on a network comprising four routers in a hub-and-spoke topology with R1 as the hub An engineer added a new spoke with multiple VCs to the network, and now traffic cannot flow properly How should the engineer update the configuration on R1 to correct the problem?

A. Disable spanning tree to allow loops to occur within the hub-and-spoke topology.

B. Disable split horizon to allow multiple VCs per spoke

C. Disable Cisco Discovery Protocol to allow MPLS to share labels between the designated spokes

D. Disable Cisco Discovery Protocol to allow for neighbor discovery