Refer to the exhibit
A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?
A. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration.
B. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family.
C. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family.
D. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.
Which statement about segment routing prefix segments is true?
A. It is the longest path to a node.
B. It is linked to an adjacency SID that is globally unique within the router.
C. It is linked to a prefix SID that is globally unique within segment routing domain.
D. It requires using EIGRP to operate.
Refer to the exhibit.
If the NetFlow configuration is updated to version 9, which additional piece of information can be reported?
A. IPv4 flow information
B. BGP AS information
C. IPv6 flow information
D. flow sequence numbers
Which statement about LDP Session Protection and LDP-IGP sync is true?
A. Both LDP features cannot be used at the same time in a MPLS LDP enabled network
B. LDP Session Protection re-exchanges label information when a down-up event occurs; LDP-IGP sync keeps the adjacency and label information in a down-up event
C. LDP-IGP sync re-exchanges label information when a down-up event occurs; LDP Session Protection keeps the adjacency and label information in a down-up event
D. Both LDP features must be used together to increase fast convergence on an MPLS LDP-enabled network
FRR is configured on a network. What occurs when the headend router on the path is alerted to a link failure over IGP?
A. LSP attempts fast switching on the backup path until the primary path returns to the active state.
B. The headend router uses a presignaled LSP to bypass the failure point.
C. A new backup tunnel is established past the PLR to pass through the protected nodes.
D. Backup tunnel is established and intersects with the primary tunnel at the headend.
Which three OSPF pieces of information must between routers in order to establish an ospf neighborship? (Choose three)
A. Area ID
B. Hello interval and dead interval timer value
C. LSA refresh period timer value
D. Priority value
E. Stub flag
F. Process ID
A network operation engineer has these requirement:
*prevent multicast transit when it is enforced by unicast stub routing.
*Reduce the overall processing of PIM control traffic. Especially when the number of stub links increases on the stub device.
*protect against multicast spoofing of PM designated router messages and PIM assert messages.
Which solution meets these requirements?
A. explicit tracking of receivers.
B. multicast stub routing.
C. Source Specific Multicast.
D. PIM allow RP.
After a series of unexpected device failures on the network. a Cisco engineer is deploying NSF on the network devices so that packets continue to be forwarded during switchovers. The network devices reside in the same holding, but they are physically separated into two different data centers.
Which task must the engineer perform as part of the deployment?
A. implement OSPF to maintain the link-state database during failover.
B. implement VRFs ana specify the forwarding instances that must remain active during failover.
C. implement an L2VPN with the failover peer to share state Information between the active and standby devices.
D. implement Cisco Express Forwarding to provide forwarding during failover
Refer to the exhibit.
A network operator working for a telecommunication company with an employee id: 1234:56:789 is implementing a Cisco Unified MPLS solution. What is the effect of this implementation?
A. BGP is deployed between the PEs and ABRs with RFC 3107.
B. EIGRP is deployed between the PEs and ABRs with RFC 3107.
C. OSPF is deployed between the PEs and ABRs with RFC 3107.
D. IS-IS is deployed between the PEs and ABRs with RFC 3107.
A network engineer is configuring a router to send multicast traffic for the 239.10.10.10 group. Which configuration must an .... forward the traffic?
A. Cisco(config)# interface ethernet 1/0 Cisco(config-if)# ip igmp max-groups action replace
B. Cisco(config)# interface ethernet 1/0 Cisco(config-if)# ip igmp filter
C. Cisco(config)# interface ethernet 1/0 Cisco(config-if)# ip igmp access-group 239.10.10.10
D. Cisco(config)# interface ethernet 1/0 Cisco(config-if)# ip igmp join-group 239.10.10.10