Which of the following parameters is not needed by Visual RF Plan in order to Plan APs on a floor region?

A. AP Type

B. PHY Type

C. Distance to Controller

D. Environment

E. Desired Data Rate

802.11n APs operate in which bands? (Select two)

A. 900 MHz

B. 2.4 GHz

C. 2.4 MHz

D. 5 GHz

E. 5 MHz

When local controller is selected as the controller's operation mode in the startup wizard, which is no longer configurable?

A. Licenses

B. WLANs

C. VLANs and IP addressing

D. Controller country code

E. Time zone

When a client is blacklisted, the controller will:

A. Send a message telling the client it has been blacklisted

B. De-authenticate the client from the network but allow it to keep transmitting data

C. Only block the client if it hasn't yet associated with an AP

D. Stop the client from associating with any SSID on the controller

E. Block the client from the SSID he was connected to

When configuring a default gateway in the startup wizard it must be a part of:

A. A VLAN configured with an IP interface and assigned to a port

B. An IP range that is not assigned to a port or VLAN

C. A VLAN assigned to a port but without an IP interface configured

D. A VLAN not configured on the controller

E. The management Vlan

Visual RF Plan requires certain building information when defining a new building. Which one of the following is NOT a user supplied building specification?

A. Building name

B. Longitude and Latitude

C. Attenuation between floors

D. Desired data rate

E. Number of APs

When configuring a guest WLAN via the WLAN section of the startup wizard, which security option is NOT available?

A. WEP encryption

B. Direct access to the internet with no captive portal

C. Captive portal with authentication via credentials

D. Captive portal with email registration

E. Captive Portal with no authentication or registration

What is the purpose of the validuser ACL?

A. When a user transmits data through the controller, the validuser ACL is used to check if the user is in the layer 3 user-table

B. Before a client is added to the controller's user table, the validuser ACL is checked to make sure the client has a valid IP address

C. The validuser ACL is used during 802.1X authentication to check that the client is in the layer 3 user-table

D. When an AP needs to transmit data to a user, it checks the validuser ACL to make sure the user has a valid IP address

E. A list of configured MAC addresses that define the valid users

Which is the strongest encryption type?

A. AES

B. TKIP

C. WEP

D. MSCHAPv2

E. DES

When looking at clients in the `Monitoring Clients' section of the Controller, which of the following information is NOT visible?

A. Role

B. MAC address

C. Output power of client radio

D. Method of authentication

E. Age