If a packet to be forwarded does not match existing flow information in the ASIC route cache, the packet is queued to the __________ for route processing

Name one of the three ExtremeWare load sharing algorithms: __________

You would use the __________ command to turn on ECMP. Do not abbreviate the CLI command.

Which of the following is not advertised in an OSPF Link State Advertisement?

A. Costs

B. Link utilization

C. Router interfaces

D. Neighbor information

Which RIP settings are enabled by default?

A. Triggered updates

B. Poison Reverse

C. Split Horizon

D. Route redistribution

When the command disable stpd port 4:1-4:8 is entered what is the result?

A. Ports 4:1-4:8 are placed into the blocking state.

B. Ports 4:1-4:8 are placed into the listening state.

C. Ports 4.1-4.8 are placed into the learning state.

D. Ports 4:1-4:8 are placed into the forwarding state.

What effect does the hierarchical model of OSPF have on network traffic?

A. LSAs are not forwarded outside of their areas.

B. Only routers in area 0.0.0.0 must run the SPF algorithm.

C. Virtual links are needed for OSPF routing to function.

D. ABRs consolidate all LSAs into one LSDB.

You are taking steps to secure SNMP access to your switches after reviewing CERT Advisory CA-2002-03 on the Extreme Networks web site. Your supervisor instructs you to configure 192.168.0.254 as the only SNMP trap receiver with read-write access. How will you do this?

A. Enter the command config snmp 192.168.0.254 trapreceiver add community private.

B. Enter the command config snmp add 192.168.0.254 trapreceiver community private.

C. Enter the command config snmp trapreceiver 192.168.0.254 add community private.

D. Enter the command config snmp add trapreceiver192.168.0.254 community private.

An OSPF router connected to a RIP network and performing route redistribution is considered: A. to be an ASBR.

B. to be an ABR.

C. to be a DR.

D. to be a BDR.

Exhibit:

You have been assigned the task of configuring an 8-port load share group between two switches that uses the address-based algorithm. Which of the following commands will provide you with the desired result?

A. Summit #1: enable sharing 1 grouping 1-8 algorithm address-based, Summit #2:enable sharing 8 grouping 1-8 algorithm address-based

B. Summit #1: enable sharing 1 grouping 1-8 algorithm address-based, Summit #2:enable sharing 1 grouping 1-8 algorithm address-based

C. Summit #1: enable sharing 1 grouping 1-8 address-based algorithm, Summit #2:enable sharing 1 grouping 1-8 address-based algorithm

D. Summit #1: enable sharing 1 grouping 1-8 address-based algorithm, Summit #2:enable sharing 8 grouping 1-8 address-based algorithm