What are three characteristics of RIPv2? (Choose three.)
A. uses Hello Protocol for neighbor discovery
B. supports Kerberos authentication
C. supports VLSM
D. multicasts messages to RIP neighbors
E. is backward compatible with RIPv1
What is the purpose of the OSPF hello packet?
A. acknowledges the receipt of update packets
B. establishes and maintains neighbor relationships
C. advertises reachable networks
D. describes the contents of the link-state database
Which CLI command shows the BGP options that have been negotiated between peers?
A. showbgp options
B. showbgp neighbor
C. showbgp summary
D. showbgp route
What are two advantages of a signaled LSP over a static LSP? (Choose two.)
A. consumes fewer router resources
B. supports failover to secondary LSPs
C. shows up in the route table as a static route
D. performs keep-alive checking
Which RP election mechanism can load balance among multiple candidate RPs by default?
A. bootstrap router
B. static
C. auto-RP
D. sparse-RP
By default, which routing table do multicast-enabled routers use to perform an RPF check?
A. inet.1
B. inet.2
C. inet.0
D. inet.3
Which two routes may be advertised via EBGP? (Choose two.)
A. routes that originate on the local router and are from protocol aggregate
B. routes that do not originate in the local AS and are learned by OSPF
C. routes that are transiting the local router and are from protocol BGP
D. routes that originate on the local router and are injected using policy
What type of hop in an ERO must be directly connected to the previous hop?
A. partial
B. full
C. loose
D. strict
For what mode must an interface be configured in order to run Auto-RP?
A. sparse-dense
B. full-mesh
C. sparse
D. dense
By default, which routing table is used to store the multicast forwarding cache?
A. inet.3
B. inet.2
C. inet.0
D. inet.1