What is the default spanning-tree mode on an Arista switch?

A. STP is disabled

B. PVST

C. RPVST

D. MST

After configuration and enabling XMPP, what command can be used to verify its status?

A. show status xmpp

B. show xmpp status

C. show xmpp server

D. show xmpp server status

In EOS, which of the following statements is the shortest acceptable abbreviation for entering global configuration mode?

A. conf

B. con

C. config

D. conf t

Many Arista switches support reversible air flow. When the fans installed on such a switch have red handles, which of the following statements would be correct?

A. Cold air will be pulled in from the port side of the switch.

B. Warm air will be pulled in from the starboard side of the switch.

C. Hot air will be pulled in from the fan side of the switch.

D. Hot air will be ejected from the fan side of the switch.

What is the EOS feature that allows switches with Multi-Switch CLI enabled to send non-interactive commands to multiple switches at once?

A. groups

B. switch-groups

C. chat-rooms

D. chat-groups

Given the following output, which of the following have you likely configured?

A. Advanced Mirroring with Packet Truncation

B. Advanced Mirroring with ACLs

C. Agile Ports

D. Buffer Tuning

When configuring MLAG, Arista recommends that the trunk group command be used on the VLAN used for MLAG peer communication.

What is the purpose of the trunk group command?

A. It groups all the trunks together so that they can traverse the peer-link properly.

B. It groups the MLAG interfaces together so that they can be reported on both peers.

C. It prevents the configured VLAN from leaking out onto other trunks.

D. It ensures that the configured VLAN will be included on all trunks.

On an Arista switch, what is the default username and password?

A. Username Admin, Password Arista

B. Username Arista, Password Admin

C. Username admin with no password

D. Username Arista with no password

Which of the following commands can you use to see which EOS versions are stored on the switch's flash drive (assuming a freshly booted switch)?

A. dir flash

B. bash ls /mnt/flash

C. dir

D. all of the above

With two switches in an MLAG domain, which of the following commands is a legitimate way to make interfaces on one of the peers part of mlag 43?

A. Peer-1(config-if-Po43) #mlag 43

B. Peer-1(config-if-Et43) #mlag 43

C. Peer-1(config-if-Vl43) #mlag 43

D. There can only be 32 MLAGs on a switch, so MLAG 43 is impossible.