Dell PowerEdge Professional Exam: DCPPE-200

Refer to the exhibit.

An engineer receives a pair of the modules shown to install in a pair of MXL switches.

Which cables does the engineer need for this module?

A. OM4 MTP Crossover Fiber Cable (optics required)

B. SFP+ to SFP+, 10GbE, Copper Twinax Direct Attach

C. QSFP+ to QSFP+, 40GbE Passive Copper Direct Attach.

D. Cat6A Snagless Unshielded (UTP) Network Patch Cable

An engineer needs to configure network port partitions for four networks that will be used on the server.

-

Partition 1 – Management network

-

Partition 2 – VM Live Migration network

-

Partition 3 – Production VM network

-

Partition 4 – Development VM network

The engineer needs to make sure the following conditions are met:

-Management and Live Migration networks do NOT exceed 1Gb

-Production VM network can use 10Gb but is guaranteed 5Gb during heavy use

-

Development VM network has maximum bandwidth capability when NOT in use by the other networks Which network port partition bandwidth settings should the engineer set?

A.

Partition 1 Partition 2 Partition 3 Partition 4 Relative Bandwidth Weight 0094Maximum Bandwidth1153

B.

Partition 1 Partition 2 Partition 3 Partition 4 Relative Bandwidth Weight 1153Maximum Bandwidth111010

C.

Partition 1 Partition 2 Partition3 Partition 4 Relative Bandwidth Weight 009040Maximum Bandwidth1010100100

D.

Partition 1 Partition 2 Partition 3 Partition 4 Relative Bandwidth Weight 1010 50 30 Maximum Bandwidth 1010 100 100

An engineer is migrating an existing server node from an M1000E to a VRTX chassis. An error message appears during POST. The system will continue to boot, but can NOT see any of the chassis shared storage or PCIe devices mapped to the server slot. The engineer has already removed the original fabric interfaces in mezzanine slot B and C from the original system configuration.

Which action must the engineer complete to allow the node to see chassis storage and mapped PCIe devices?

A. Enable PCIe Pass-Through in System Setup

B. Remap chassis storage/PCIe devices

C. Install PCIe Pass-Through mezzanine cards

D. Update the CPLD firmware version