Your WAN links are on a VPLS service from a single service provider. You must verify device configuration power and status in the event of a service outage. Which two actions provide out-of-band management to your edge routers? (Choose two)

A. Place management traffic on a separate VLAN on the VPLS service

B. Connect each Ethernet management interface to a dedicated switch with traffic routed on its own subnet on the VPLS service

C. Connect each Ethernet management interface to a dedicated switch with its own WAN connection.

D. Connect each serial management port to a console server with a cellular Internet connection

Exhibit: You are asked to ensure that most traffic that traverses your network is load balanced over all of the equal cost links between the routers in your network. However, you must also ensure that traffic from ISP A that is destined for ISP D must traverse the R1-R2-R3-R4-R5 path. Referring to the exhibit how would you accomplish this task?

A. Force the ISP A to ISP D traffic over RSVP-signaled LSPs.

B. Adjust the BGFs LOCAL PREF attribute to ensure that the raw IP packets follow the required path.

C. Adjust the OSPF metrics of each link so that the raw IP packets follow the required path.

D. Force the ISP A to ISP D traffic over LDP-signaled LSPs.

Your backbone network has a single dark fiber between two backbone sites within the same metro area.

Currency this link is being used as a point-to-point 100ObE link between the routers using gray optics. The

link has been experiencing high utilization and you are asked to propose network design changes to

increase capacity across this network segment.

Which statement is true in this scenario?

A. New optical interfaces will need to be added to the routers.

B. Interfaces need to be reconfigured for 200GbE.

C. Gray optics can be used to increase capacity by enabling additional wavelengths.

D. Enabling MPLS will increase capacity due to statistical multiplexing.

You want to implement Source Packet Routing in Networking (SPRING) in your network core using MPLS as the data plane for traffic engineering purposes. In this scenario what are two protocols that would be used to distribute the segment IDs? (Choose two )

A. OSPF

B. RSVP

C. LDP

D. IS-IS

Exhibit:

You are asked to design a solution that will provision a circuit from the corporate headquarters to a remote

branch. The circuit must be secure, and must support IGP adjacencies. IPsec has been chosen to secure

traffic across the WAN connection.

Referring to the exhibit which statement describes another requirement for this circuit to function correctly?

A. You must use a service provider Layer 2 VPN to establish routing protocols across the circuit.

B. You must use a service provider Layer 3 VPN to establish routing protocols across the circuit

C. You must implement GRE over IPsec to establish routing protocols across the circuit.

D. You must increase the MTU of the IPsec tunnel to more than 1500 bytes to allow routing updates across the circuit.

You are asked to provide a proposal for a service provider's OSPF network. The customer is concerned about the volume of link-state advertisements within their network and want to limit this traffic. Given this scenario which design component would satisfy the customer's requirement?

A. Use the same AS number.

B. Use multiple areas.

C. Use multiple levels.

D. Use the same router IDs.

You are asked to prepare a design proposal for a new enterprise customer. You must ensure that all traffic is routed through and inspected by an SRX Series device located at the corporate headquarters. In this scenario which solution should be used?

A. Use a full mesh SD-WAN solution

B. Use a full mesh Layer 3 VPN solution

C. Use a Junos Fusion Enterprise solution

D. Use a hub-and-spoke Layer 3 VPN solution

Exhibit:

Referring to the exhibit, which two methods would be used by the designer of ISP E to ensure that traffic

between ISP C and ISP A will traverse through ISP B? (Choose two.)

A. Apply the BGP import policy (to EBGP peers) on R4 anaVor R5 to adjust the local preference on the ISP C routes so that the path through ISP B is more preferred

B. Apply the BGP export policy (to IBGP peers) on R4 and R5 to adjust the MED on the ISP C routes so that the path through ISP D is less preferred.

C. Apply the BGP import policy (to EBGP peers) on R4 and R5 to modify the AS PATH attribute so that the path through ISP D is less preferred.

D. Apply the BGP import policy (to EBGP peers) on R4 to adjust the ORIGIN for the routes received from ISP B to unknown.

Your customer requires redundant routers and wants to use VRRP for the default gateway at their Internet edge. Which two statements are correct in this scenario? (Choose two )

A. VRRP will only support two routers

B. The VRRP master and backup send advertisements to each other at regular intervals.

C. VRRP dynamically elects master and backup routers

D. VRRP for IPv6 provides a much faster switchover to an alternate default router than IPv6 neighbor discovery procedures

You are designing a solution for an energy trading organization that allows them to stream natural gas prices to trading partners. Prices will be streamed to trading partners using the Internet. Trading regulations require that any trading data streamed over a public network must be encrypted and authenticated. Which connectivity solution meets these requirements?

A. L2VPN

B. IPsec

C. VPLS

D. L3VPN