You have a server which is booting from a SAN. After adding new SAN storage to a host, the host will not boot from the SAN.

What will resolve this problem?

A. LUN masking

B. Persistent binding

C. Trunking

D. Multiplex binding

You are designing a security solution for a storage array which stores customer credit card information.

Data on the storage array must be encrypted and if necessary, you want to be able to revoke access to data on demand.

In addition to encryption, which solution would allow you to do this in a secure and automated fashion?

A. Use a manual record deletion solution.

B. Physically destroy hard drives holding the data

C. Store data indefinitely.

D. Use the key management solution.

What should be considered when implementing remote replication of storage?

A. The IOPS requirements at the primary site

B. The geographical location of the primary site

C. The availability of communication links

D. The availability of server hardware at the secondary site

Click the Exhibit button.

The physical interface shown in the exhibit is taken from which transport protocol?

A. Ethernet

B. FCP

C. FCoE

D. InfiniBand

You have been hired as a consultant to help resolve boot-from-SAN server reboots. The company has hosts, storage devices, and tape drives in the same zones. A large number of RSCNs are generated during the backup window.

What is the cause of the problem?

A. Tape drives are more sensitive to RSCNs than hosts or disk storage devices.

B. Storage devices and tape drives are configured within the same zone.

C. Storage devices are more sensitive to RSCNs than hosts or tape storage devices.

D. Most SAN switches do not support having both disk and tape frames flowing over the same switch ports at the same time.

Which protocol commonly uses CNA devices?

A. FCIP

B. iFCP

C. FCoE

D. FCR

Your company asks you to increase restore speeds. What should you do?

A. Upgrade existing LTO3 drives to LTO5 drives to take advantage of faster read/write speeds and larger tape cartridge sizes.

B. Add a mirrored disk based backup target that can be used for backups that support point-in- time recovery.

C. Attach the existing tape libraries to a backup server with local drives configured with RAID 5.

D. Attach a JBOD drive array to the backup media server to improve the read performance of the backup catalog.

A server has lost half of its paths to its LUN on a storage system. The help desk determines that one of the two HBAs was just replaced. The SAN administrator has modified the zoning with the new WWPN of the replacement HBA port, but the missing paths have still not recovered.

Which action would you perform next?

A. Rescan disks on the server.

B. Reconfigure persistent binding on the server.

C. Reboot the server.

D. Modify the host definitions for LUN masking on the storage system.

You are provisioning storage to a host with multipathing software installed and correctly configured. You discover that there are four paths to LUNs instead of the expected eight paths.

Why does this happen?

A. Incorrect zoning

B. Incorrect multipathing policy

C. Incorrect LUN masking

D. Incorrect LUN size

What is the maximum distance between two 8 Gb FC ports that can be connected using 50 µOM3 grade multimode fiber cable?

A. 500 meters

B. 300 meters

C. 250 meters

D. 150 meters