Aruba Certified Mobility Expert 8 Written Exam: HPE6-A48

Refer to the exhibit.

A network engineer deploys two different DHCP pools in an Instant AP (IAP) cluster for WLANs that will have connectivity to a remote site using Aruba IPSec.

Based on the output shown in the exhibit, which IAP-VPN DHCP modes are being used?

A. distributed L3 and centralized L3

B. distributed L3 and local L3

C. distributed L3 and centralized L2

D. local L3 and centralized L2

Several users are connected to the same WLAN and want to play the same multicast-based video stream. The network administrator wants to reduce bandwidth consumption and at the same time increase the transmit rate to a fixed value for WMM marked video streams in a large-scale network. Broadcast Multicast Optimization (BCMCO) is already on.

Which two configuration steps does the network administrator have to perform to optimize the multicast transmissions? (Select two.)

A. Enable Dynamic Multicast Optimization (DMO) and set forwarding mode to tunnel in the VAP profile.

B. Enable Broadcast Multicast Rate Optimization (BC/MC RO) in the SSID profile.

C. Enable Broadcast Multicast Optimization (BCMCO) and set forwarding mode in the VAP.

D. Disable Broadcast Multicast Optimization (BCMCO) in the VLAN.

E. Set Video Multicast Rate Optimization (VMRO) in the SSID profile.

Refer to exhibit.

A company has a multiple Arua implementation with three different locations named Headquarter, Branch,

and Telecommuters.

The network design includes the following:

Headquarter APs terminate at the Mobility Controller (MC) cluster and propagate Corporate, Guest, and

Voice SSIDs

Branch APs terminate at the Branch Office Controller (BOC) and propagate Corporate and Voice SSIDs

BOC reaches the Mobility Master (MM) through a VPNC.

Telecommuter RAPs terminate at VPNC and propagate Corporate and Voice SSIDs.

The Corporate SSID on the RAPs is split-tunnel, all other SSIDs are tunnel.

The network design requires minimal AP group and VAP configuration effor, while preventing unnecessary

VAP propagation to lower hierarchy levels.

Following Aruba node hierarchy desing recommendations, which group hierarchy design helps meet these

requirements?

A. /md /md/Corp1/ /md/Corp1/Offices /md/Corp1/Offices/Headquarter /md/Corp1/Offices/Branch /md/Corp1/Telecommuters /mm /mm/mynode

B. /md /md/Headquarter /md/Branch /md/Telecommuters /mm /mm/mynode

C. /mm /md/Locations /md/Locations/Headquarter /md/Locations/Branch /md/Locations/Telecommuters /mm /mm/mynode

D. /md /md/Location1/ /md/Location1/Branch /mdLocation1/Offices /md/Location1/Offices/Headquarter /md/Location1/Telecommuters /mm /mm/mynode